Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the drivers seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type CZH4278 where you lift the rod to engage reverse.
"Remote" gearshift boots 22A608 are readily available in aftermarket quality. Unfortunately, this metal retaining band had been unavailable from normal sources so we at Mini Spares recently took it upon ourselves to have our own manufactured. Fit and finish is excellent. We think they're a pretty good replica!
the actual gear lever gaiter screwed to the floor to stop draughs coming up. for rod change gearbox models only. the metal retainer that screws to the floor to hold this gaiter is FJN10003
the metal retainer that holds the rod change gear lever gaiter CZH4278 in place
Magic Wand rubber shift boot.The first Minis had a very simple gearchange, the lever exits the transmission directly through the floor. This requires a special boot to accommodate the curves in the floor and tunnel and being rubber it eventually cracks with age and flexing. Replace it with the real thing to keep wet or dry road crud out of the car. See...
THIS IS THE ROUND GAITER 3.5" WIDE THAT KEEPS THE DIRT FROM GETING INTO THE MAGIC WAND TYPE GEARBOX ON 850CC MINIS. IT IS NOT THE GEARLEVER GAITER THATSITS ON THE CAR FLOOR, THAT IS 14A6860.
Actually the concertina dust cover for the rod change oil seal to prevent road debris attacking the seal. See MSSK050 kit when undertaking this job.